RedCore R-4 Manuale Utente Scaricare il pdf (Pagina 7)

Figure 5

Note: The leads have NOT been prepared. Do not forget to do this.

Now we are ready to build the kit. It is important that you build it in the sequence given in order

to be able to get to all parts to solder.

Step 1. Solder in toroids 1 through 5, making sure that you get a good solder joint. Check all

joints with a volt – ohm meter for continuity. To do this go to a point that is connected to the

toroid lead by a trace on both ends and check for continuity. You should see a dead short.

Figure 6 – Toroids 1 – 5 Mounted

Step 2. Take all of the switches and remove all hardware except for the bottom nut. Loosen the

nut so that you can slip the pcboard between the nut and the base of the switch, about 1/16”. This

sets the spacing of the board from the top of the case.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Nessun commento

RedCore R-4 Manuale Utente Pagina 7