RedCore R-4 Manuale Utente Scaricare il pdf (Pagina 13)

Figure 17 Case top with mounted label

Now we are ready for final assembly.

Step 14. Mount the board to the top of the case, using all nuts and screws. Be careful to not

tighten too tight on the template.

Step 15. Mount the BNC connector in the hole where it goes. Be sure and tighten the nut securely.

Next solder a connector wire between the center conductor and the rig connection on the board.

Now solder a connector wire between the ground connection and the G on the board near S6.

Figure 18 BNC Connections

Step 15. Mount the two 5-Way Binding Posts on the other end of the case. Run a wire from the

center conductor to the Ant connection on the board near L5. Run another wire from the center

conductor of the other binding post to the G connection near L5.

1 2 ... 8 9 10 11 12 13 14 15 16

Nessun commento

RedCore R-4 Manuale Utente Pagina 13